Sensitivity Test: TO BE PEFORMED BEFORE EACH APPLICATION.
1. Mix 1cm of dye cream with 1cm of activating cream.
2. Apply a small amount to a small area on the inner bend of the elbow, or behind the ear.
3. Allow to dry and leave uncovered 48-72 hours. If no irritation or rash occurs during this time, the chance of a reaction during treatment is very much less, but is never certain. If any sign of irritation or rash occurs, wash the area thoroughly and do not carry out the treatment and stop using this product immediately.
Use: IMPORTANT: Once the dye cream and the Activator Cream have been mixed, they should be used immediately.
1. Cleanse your eyebrows with a non-oily cleanser to remove make up and natural oils. Dry thoroughly.
2. Prepare one eye at a time. Carefully spread barrier cream, like petroleum jelly, over the skin and around the eyelids, but avoid getting on the hairs to be tinted.
3. Pierce Cream Colour Dye tube nozzle with sharp end of end of cap and squeeze approximately 2cm of Dye Colour into the mixing dish; replace lid immediately.
4. Squeeze approximately 2cm of Activating Cream into the same mixing dish; replace lid immediately.
5. Mix both creams together to form a creamy solution.
6. Close the first eye and apply the cream mixture to the eyebrows using the mascara wand. If the cream touches the skin, wipe off immediately with damp cotton wool.
7. Leave the cream on the eyebrow for 5-10 minutes, keeping your eye closed throughout. The average application is 10 minutes but it can be increased or decreased depending on the desired intensity of the colour and the hair type. With the eyelid still closed, using a damp cotton wool pad to gently wipe the excess mixture from the eyebrow using upward strokes away from the eyelid. Rinse thoroughly with water. If slight stinging should occur flush with an eye bath of water. Repeat on the other eye.